14×20 Concrete Slab (6 inches): Yards, Feet & Bags
This 14 ft x 20 ft slab is perfect for a patio or gazebo base. Decide between bags or ready-mix based on your access and project size.
Choose Your Calculator
Slab Calculator
Enter any custom length, width, and thickness to get cubic yards and bag counts.
Open Slab CalculatorBag Calculator
Choose 40/60/80 lb bag sizes and estimate counts for your exact volume.
Open Bag CalculatorWant other sizes? Browse all slab size pages
Quick Answer
Tip: Always confirm the yield printed on your bag label. Bag yield guide
Large pour: consider ready-mix delivery for speed and consistent results. Bag counts this high can take significant mixing time.
Project Notes (Unique)
Round to 0.25 yd³ when ordering and check yield on the label to ensure you have enough material.
Ensure your base is well-prepared and forms are secure, especially for thickened edges to prevent shifting.
Finish the surface as desired and allow adequate time for curing under favorable conditions to achieve strength.
Choosing the Right Slab Thickness for 14×20
A 6-inch slab gives this patio extra stiffness and tolerance if soil conditions are imperfect or loads may grow over time.
Current spec
This page estimates a 14×20 slab poured at 6 inches.
Load check
Best fit depends on whether this is mainly pedestrian use, storage, or heavier wheel traffic.
Upgrade trigger
If you expect heavier loads later, compare this design against the alternate thickness before ordering.
Base Prep Checklist for a 14x20 Slab
Most slab problems start below the concrete. Keep the base level, compacted, and consistent before you pour.
- Strip loose topsoil and organic material until you reach firm subgrade.
- Compact the base in lifts so the 14×20 slab does not settle unevenly.
- Check form height and diagonal measurements before concrete arrives.
- Plan reinforcement, joints, and edge support based on the intended patio use.
Worked Example for 14×20 at 6 Inches
Step-by-step calculation for this exact slab:
- Convert thickness to feet: 6 ÷ 12 = 0.5000 ft
- Compute area: 14 × 20 = 280 sq ft
- Volume in cubic feet: 280 × 0.5000 = 140.00 ft³
- Convert to cubic yards: 140.00 ÷ 27 = 5.185 yd³
- Add 10% waste buffer: 5.185 × 1.10 = 5.704 yd³
Concrete Delivery Strategy for 14×20
This slab needs about 5.19 yd³ of concrete, or 234 80 lb bags before waste. With a waste cushion, plan around 5.70 yd³.
For this volume, ready-mix is usually the safer plan. Round up, confirm delivery minimums, and make sure your crew can place and finish the slab without delays.
Adjust dimensions in the slab calculator or compare bag counts here.
Bag Counts by Waste Buffer for 14×20
Pick a buffer based on site conditions: smooth forms and good subgrade can run leaner; uneven excavation or hard-to-reach pours need more cushion.
| Buffer | Yards (yd³) | 80 lb bags | 60 lb bags | 40 lb bags |
|---|---|---|---|---|
| +5% tight pour | 5.44 | 245 | 327 | 490 |
| +10% typical | 5.70 | 257 | 343 | 514 |
| +15% rough subgrade | 5.96 | 269 | 358 | 537 |
When a 14×20 Slab Is Ready to Use
Protect the slab after finishing, keep the surface from drying too fast, and avoid heavy service until the concrete has had time to gain strength.
First 24 hours
Protect edges, prevent washout, and avoid unnecessary traffic while the slab sets.
Days 2-7
Maintain curing conditions and monitor joints, surface drying, and weather exposure.
Up to 28 days
Concrete keeps gaining strength, so wait for the right service window before heavy use.
How to Estimate This Slab in 3 Steps
Measure
Length 14 ft, width 20 ft, thickness 6 in.
Compute Volume
Area: 280 sq ft → volume: 140.0 ft³ → 5.19 yd³.
Add Waste
Add a small buffer for spillage and uneven subgrade, then round up when ordering.
Planning Notes
Common uses: patio, gazebo base, walkway section.
For more context and conversions, see the Concrete Calculator hub.
Frequently Asked Questions
What should I consider when choosing between bags and ready-mix concrete?
Consider your access to the site, the volume needed, and how much time you have for mixing.
How do I ensure I have enough concrete for my project?
Factor in a waste buffer and round your calculations up to account for any spillage or miscalculations.
What is the best way to prepare the base for my concrete slab?
Clear the area of debris, level the ground, and compact the soil to create a stable foundation.
How thick should my concrete slab be for a patio?
A thickness of inches is generally suitable for most patio applications, providing durability and support.
Related Slab Sizes
Ready to Calculate Your Project?
Get instant estimates for cubic yards, cubic feet, and bag counts. No signup required.